Gallery, Projects and General > Project Logs
'Poppin' Flame Licker
<< < (15/30) > >>
sbwhart:
Nick

Cant you just replace the screw with a rasping big set screw M12 ish the nut will be easy then.

Stew
NickG:
Thanks for the advice guys. Stew, yes I did think of remaking the screw as well to make the nut easier! M12 is about the largest tap and die I have I think but that is still quite a bit smaller than the 5/8" thread it is at the moment. Would probably sill be plenty strong enough though I would think.

Nick
andyf:
Nick, this place sells 5/8" x 10TPI Acme flanged nuts. No prices on their website, though!

Andy
NickG:
Andy,  :doh: you missed the link out!  :lol: This vice problem has stopped me in my tracks a bit but I don't want to chuck it out for the sake of a tap or a nut or whatever, it's too good.

I've been pretty slack lately too, just can't be bothered to get in the garage to tell you the truth, but I will soon.

nick
jim:

--- Quote from: NickG on March 19, 2010, 02:32:51 PM ---
I've been pretty slack lately too, just can't be bothered to get in the garage to tell you the truth, but I will soon.

nick

--- End quote ---

normal service will be resummed at my workshop next weekend!!!
Navigation
Message Index
Next page
Previous page

Go to full version