« previous next »
Pages: [1]   Go Down

Author Topic: How do I remove a pulley?  (Read 3859 times)

Offline raynerd

  • Madmodder Committee
  • Hero Member
  • *****
  • Posts: 2893
  • Country: gb
    • Raynerds Projects - Raynerd.co.uk
How do I remove a pulley?
« on: January 18, 2010, 01:04:22 PM »
I need to remove the pulley from my X2 mill and I don`t have a pully puller. I know for a fact the answer is on this forum as I have been in a similar problem a while ago and someone replied to how I should have removed the pulley. I can`t for the life of me find it via search or remember where it was.

I`d really like to give this a crack tonight so if anyone could post up some advice. The method really must leaver off the shaft or it`ll spoil the motor. I know the method is likely to involve a bolt but can`t think how it will be arranged.

Hope someone can help me out. All the best
Chris
Logged

Offline Darren

  • Madmodder Committee
  • Hero Member
  • *****
  • Posts: 3795
  • N/Wales
Re: How do I remove a pulley?
« Reply #1 on: January 18, 2010, 01:09:19 PM »
Logged
You will find it a distinct help… if you know and look as if you know what you are doing. (IRS training manual)

Offline raynerd

  • Madmodder Committee
  • Hero Member
  • *****
  • Posts: 2893
  • Country: gb
    • Raynerds Projects - Raynerd.co.uk
Re: How do I remove a pulley?
« Reply #2 on: January 18, 2010, 02:35:12 PM »
What do you mean - what is it?

It looks like a puller to me!
Logged

Offline raynerd

  • Madmodder Committee
  • Hero Member
  • *****
  • Posts: 2893
  • Country: gb
    • Raynerds Projects - Raynerd.co.uk
Re: How do I remove a pulley?
« Reply #3 on: January 18, 2010, 02:47:31 PM »
Logged
Pages: [1]   Go Up
« previous next »