Gallery, Projects and General > How to's

Fixing a Moore & Wright level

<< < (5/7) > >>

briary9:
Thanks for the tip, I will look out for future posts.
briary9

philf:

--- Quote from: briary9 on August 09, 2014, 07:07:09 AM ---Hello bogstandard,
I to have had the 50.00 min charge thrown at me. I wonder if the spare precision vials you have will fit my imperial Rabone Chesterman machine level. The viewing window in my level is 2-1/2 inches long and the vial is1/2 inch in diameter.

Regards briary9

--- End quote ---

Don't hold your breath waiting for a reply from bogstandard - he no longer posts on here.

I had a vial replaced by Starrett a few years ago. I can't remember how much it cost.

Have a look at http://www.leveldevelopments.com/products/vials/ground-vials/5895101-ground-vial-58x12mm-sens-0-05mmm/ - this one may fit. (Again I don't know how much it would cost or what their minimum order is.)

Phil.

Arbalist:
He did post on one of the forums the other week, trouble is I can't remember which one! :(

PTsideshow:
John "bog" has been banned from this forum. He was given more than a few chances to change is posting behavior. He choose not to. I believe he was on http://www.homemodelenginemachinist.com/index.php
 :nrocks:

philf:
Cromwell tools sell the Moore & Wright vial for 22.08 inc VAT but there's 4.99 (inc VAT) postage on top. If you spend 50 the order is post free. The vial is 85mm long (it doesn't mention the diameter).

https://www.cromwell.co.uk/M%26W3982106G

Phil

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version