Gallery, Projects and General > Project Logs
Another version of how not to build a model engine
sorveltaja:
Thanks for the replies :thumbup:.
Piston/cylinder fitting is in progress. Although 3/4 is done, it's quite tedious job to do, as I have to do it manually. I tried using lathe for that, but piston gets too easily stuck in the cylinder. So tight, that it has to be hammered out.
I really don't prefer to do that. That's the reason, why I do the job manually.
One may ask: "why don't you use o-rings?". During the process, I have indeed looked for an easier way to make tight cylinder/piston fitting.
I have read about successful use of Viton as piston ring(s). Viton is available here, but it's rather expensive.
Anyway, I have enough ptfe(teflon) to make o-rings, as an alternative, as it stands heat, and doesn't require lubrication.
sorveltaja:
Piston fitting is now done. After short run-in in lathe with plenty of oil, piston moves smoothly in cylinder:
Compression feels good, and it's again about the time to restore the engine to its glory running condition :ddb:.
Bernd:
S,
Can't believe the dedication you have put into this engine. Your perseverance has been unbelievable. I hope this engine turns out to be a good runner after putting that much effort into it. I know I wouln't have had the patients to carry on as far as you have on one project. :clap: :thumbup:
This thread will hopefuly inspire others to carry through to the end on their project.
Bernd
NickG:
Very true Bernd. Today I've been looking at the poppin plans (another flame licker) incase I can't get mine going - even down to what materials to buy! But that is pretty negative so am going to follow in S's footsteps and concentrate on trying to get mine running for a bit first!
Nick
Stilldrillin:
--- Quote from: Bernd on December 22, 2009, 09:45:41 AM ---S,
Can't believe the dedication you have put into this engine. Your perseverance has been unbelievable. I hope this engine turns out to be a good runner after putting that much effort into it. I know I wouln't have had the patients to carry on as far as you have on one project. :clap: :thumbup:
This thread will hopefuly inspire others to carry through to the end on their project.
Bernd
--- End quote ---
S`s avatar prompts me to say , he`s certainly showing "dogged determination"....... :lol:
Sorry..... ::)
David D
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version