Gallery, Projects and General > Project Logs
Another version of how not to build a model engine
NickG:
S, the cylinder wall looks extremely thin! Is there any particular reason for that?
Nick
sorveltaja:
Nick, when looking it afterwards, I have no idea why I made it so thin. Must have been some brainstorm .
But in any event, new cylinder wall is about five times thicker (1.2mm(~0.047")), than on the previous one (0.2mm(~0.0078")).
Brackets are now filed, and ready for silver soldering:
If all goes well, after soldering, I'll continue the lapping session.
NickG:
The new one looks much more substantial, good luck.
sorveltaja:
Soldering session went ok. Parts soldered together, after some lathe treatment, and cleaning:
chuck foster:
looking good sorveltaja :thumbup: ............... i know the feeling about making part's over and over again. :dremel:
the new cylinder looks allot better, more solid. good luck with the lapping.
looking forward to the next write up. :ddb:
chuck :wave:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version