Gallery, Projects and General > Gallery

A little afternoon project

(1/3) > >>

kvom:


It's a mount for a CB radio antenna for the Jeep, that mounts in the same place as the original radio antenna:

Bernd:
Looks like it mounts to somewhere on the side of the vehicle. I would think you would wipe that out in the first time you side swipe a small tree. Or do you try to avoid those small tress and bruch when off roading.  :lol:

Bernd

tinkerer:
That looks great. Where does the wire go? Do you just plug it in the nipple on the inside?

kvom:
It's possible it could get hit.  If so I'll move the mount elsewhere or make a new one.  A branch would brush over (antenna is fiberglass).  In any case it's only am inch off the side.  I put it there as being the only place to mount it not requiring additional holes in the sheet metal.  The alternate spot would be at the rear.

The cable screws into the bottom of the fixture.

websterz:

--- Quote from: tinkerer on November 06, 2009, 05:00:26 PM ---That looks great. Where does the wire go? Do you just plug it in the nipple on the inside?

--- End quote ---

Hehe...hehehe...hehe...he said nipple... :lol:

Navigation

[0] Message Index

[#] Next page