Just a quick note. I`m after some cz120 engravers brass sheet 16G - 20G, apparently has a higher lead content and machines better. I`m after plate and recently tried some scrap plate I had lying around - it was found to be sticky brass and machined badly. Cz120 is expensive as the only source I can find is to a captive market (ian cobbs - clock making brass-UK) I have quite a large selection of brass bar stock from 2" down. Would it be worth parting a disk off the end and trying this? It is just for cutting another practice wheel more than anything.
My thoughts were that sticky brass was a cheap sheet brass and that bar stock off cuts may machine better without the expense.
Any brassy information on the subject? Is it worth me just paying out...?
Chris