« previous next »
Pages: [1]   Go Down

Author Topic: Which Mill ?  (Read 3824 times)

Offline mcr

  • Jr. Member
  • **
  • Posts: 61
Which Mill ?
« on: October 29, 2009, 03:52:28 PM »
I am looking to purchase a Milling machine at the moment II have about £500 in the kitty can anybody give advice?
Logged

Offline Darren

  • Madmodder Committee
  • Hero Member
  • *****
  • Posts: 3795
  • N/Wales
Re: Which Mill ?
« Reply #1 on: October 29, 2009, 04:39:24 PM »
That's like asking what colour I'd like my next car to be ....  a bit open...

Maybe if you hinted at what you had in mind and what you you are planning to make ....  :thumbup:
Logged
You will find it a distinct help… if you know and look as if you know what you are doing. (IRS training manual)

Offline mcr

  • Jr. Member
  • **
  • Posts: 61
Re: Which Mill ?
« Reply #2 on: October 29, 2009, 04:59:50 PM »
I became frustrated using my conquest lathe to mill in producing this engine Darren.
I think that this the area I would continue in mainly marine steam for use in RC boats.
Logged

Offline NickG

  • Madmodder Committee
  • Hero Member
  • *****
  • Posts: 1890
Re: Which Mill ?
« Reply #3 on: October 29, 2009, 05:28:47 PM »
This looks a decent buy for £500 http://www.amadeal.co.uk/acatalog/AMA16V.html not sure it's got much more capacity than the conquest but more sturdy.

I got this http://www.amadeal.co.uk/acatalog/XJ20.html about a year or so ago but only paid £600 back then, it's gone up somewhat now though. Same one in Chester is a lot more http://www.chesteruk.net/store/century_vs_mill.htm

Nick
Logged
Location: County Durham (North East England)
Pages: [1]   Go Up
« previous next »