noticed my lathe (sieg C4) making funny noises winding the cross slide across.
worried that there was a problem i stripped the whole thing down, its a bit more involved because of the power feed on the cross slide.

i stopped messing around with the camera at this point, oil and swarf were getting every where!!
took it all to bits, trying to find the problem!
i couldn't find anything wrong! ( in fact it all looked very good, given the amount of work it does)
it was when i put it all back together i found a few bits of stray swarf in the handwheel beaings for the cross slide

atleast it all got a good clean
