This is my third project with the X2 mill. I could probably buy clamps, but making stuff is so much fun...plus the learning experience. I also got to use the angle blocks I made earllier.
I milled the angles on the small clamps, and even that was painstaking. Yes, Santa, I NEED a bigger mill. So I knew I had to lop off the wedges on the bandsaw. I was very surprised...The setup worked so well that I only needed a 5-10 thou finish pass. Too bad I don't know anyone who needs clamps, as I hated to take the setup down.

I didn't take any pics of drilling the holes, as that's pretty boring.
This is what I have right now:

And there it stands until I make a knurler for the handles. That's the kitchen counter and I'm single, so it might just stay right there for a while.

Mike