I have an idea for the saddle stop that would give me
1 ) Quick set up
2 ) No loss of any dimention / function
3 ) Can be used to as a left or right hand stop?
4 ) IS THRE ANY THING I DIDNT THINK ABOUT??????????
Il post thw bas and wait for some feedback / warnings before commiting to the design.
Some 25 mm MS

Drilled 8.5mm to 35mm and 5 mm all the way and tapped 10m to 15mm

Then cross drilled at 12mm


And placed in position to allow me to check that it is all practical

The idea is the make 2 grub screws with knurled knob so the 12mm bar can be removed completely if necc, but by moving the bar to the right a bit stops etc. can be added or removed as necc.
Also if a multi position stop is needed it could simply be slid onto the bar and the bar locked in place again.
But can anybody see any problems with this idea????
Gerhard