I just wanted to add a little note to the end of this build log.
I've noticed on madmodder and HMEM some folk are working hard on improving their chinese-made machines and ironing out any imperfections in their lathe and mill, and I am now doing the same thing to my lathe and mill as well.
But dont let that fool any of you who may be wondering about getting one of these into thinking that you have to do a whole load of work on them before you can make any "fun" projects. I bought both my X2 mini-mill and my C2 mini-lathe from axminster (free postage to northern ireland
![:thumbup:](https://madmodder.net/Smileys/default/happy0034.gif)
) and apart from cleaning off the red grease that was liberally spread over every concievable surface (and then some more), bolting them to a worktop and then plugging them in, I have done virtually nothing to the machines themselves. The only thing I did was to get a quick-change toolpost for the lathe and also a ER32 collet set and arbors for lathe and mill, and built a belt-drive for the mill which just made it quieter and smoother running.
My hope was to build a couple of engines and then turn to improving my machines after I was a little more experienced in machining.
These machines have improved a lot in their out-of-the-box state, and I have proved that you can make some fairly precision parts on them without having made a raft of improvements to them. Yes, I am in no doubt that there are many improvements that can be made and that these will greatly improve the ability and repeatability and accuracy of the machines, but dont be put off from getting one of them if that is what you can afford, you can make some very good parts and engines with them, and then you can use them to make parts to improve the machines themselves.
Tim