Thanks Stew, aint that the truth. When I started to assemble all the bits together, I had to go back over the plans in order to find out what went where, it had been so long since I started it I had forgotten
![:doh:](https://madmodder.net/Smileys/default/doh-45.gif)
Now that I've had it apart a couple of times, and back together too, I am getting to know it a bit better.
At first I was going to go at it with all guns blazing, kinda like "right, lets re-make everything at one time and then try again" sorta attitude. But then calmness and reason set in and I realised the truth of what you said, work at the problem methodically. So I removed the part that I thought was the issue ( the reversing/speed control valve ) and applied air direct to one piston valve/cylinder at a time, and that was where I found
the one of the problems with the escaping air.
So now I can re-make the other piston valve ( which, by the way, leaked worse than the one I just remade ) and sort out the binding con-rods and then try running it again.
So, step by step it is, I am learning that with these little engines, it only takes parts to be a fraction off the size that they need to be in order for things to either bind up or be too loose a fit. All part of the learning process.
Tim