Is that your own design or a modified one?
Eric
Have one of those Steam and Sterling books. Looked through it for something to make. The 3 cylinder wobbler looked good, "hey I can do that with what I have" wrong!
Maybe a 2 cylinder, wrong again. Good thing this one worked, I was running out of cylinders. The bride would say that happened a long time ago.
Drew it out trying to keep it within the old "Golden Rectangle" bit for eye appeal. I just find it curious why some things just look better than others. Probably should measure out the final result to see how far off the end results were. Have noticed a lot of the Elmer engines seem to fit within these boundaries, got to be some reason they are so well liked.
Was a good learning experance. Can appreciated the talents of others. Cranks a one piece, lots of thump thump thump turning that down from a hunk of round. Cylinder, pivot pin also a one piece, a 2x2x4, thump, thump, thump. I sure see why a lot of soldered build ups are done, but I always make the easy harder than it needs to be.
Hey I'm retired and mowing the yard, BLAH
Robert