The Shop > Tools

Fitting a Multifix Aa

<< < (2/4) > >>

smiffy:
I have 3 of the larger AA size toolholders and they all have 2 holes at 180 degrees

philf:
I'd just put a toolholder in and set it with a square.

Dell:
That’s what I had done up until now but when I last used a knurling tool the whole lot moved hence wanting to add a single pin.
Dell

philf:
Dell,
What sort of knurling tool are you using?
The clamp style knurling tool is far better for your lathe than the standard (one sided) type and isn't likely to move your tool post.
Phil.

philf:
Dell,

I've done a bit more Googling and have found sections through the toolpost and even a photo of a spare body. All show through holes! Have you taken the top cover off to have a look?

I know this is a bigger Multifix but clearly shows the holes at the top.



Phil.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version