Gallery, Projects and General > How do I??

Rotary Table Centreing

<< < (6/6)

Stilldrillin:

--- Quote from: Bluechip on July 03, 2009, 05:53:33 AM ---Yup, OK when you've seen it done. Not so obvious if not ..
--- End quote ---

And when you`ve done it for a while........ You take it for granted, that everyone knows......  ::)



--- Quote from: Bluechip on July 03, 2009, 05:53:33 AM ---Works well for me now   thanks to Dave SD all is sweetness and light.. till summat else crops up I suppose ..

Dave BC

--- End quote ---

In which case, you know where I am, and me number.......  :thumbup:

David D

kvom:
The DTI method is the most accurate, but can take a bit of time.  One fairly quick method is to clamp a bull center in the spindle and adjust the table until the center seats evenly in the RT center hole.  This is accurate to a couple of thousands.  Another method is to have a plug in the RT hole with a bored hole in the center.  Chuck a piece of drill rod that matches the hole and center the table so that the rod can enter that hole.

Darren:
Sounds good to me   :thumbup:

Navigation

[0] Message Index

[*] Previous page