As regular readers will know, I have recently acquired a 'new to me' JCB 3CX Project 9 excavator. The excuse being that I have a considerable length of ditches, streams and a pond that have silted up over the years and need sorting.
https://www.madmodder.net/index.php/topic,13429.0.htmlSo what is the task - well I have about 80 yards of genuine ditch that is totally choked. A largish pond that started life 8 foot deep but is pretty well silted up. And best part of 3/4 of a mile of stream that although it flows, is pretty choked with vegetation and fallen branches.
Up until now the ground has been too soft to get it out in the field and start work, however today it was just about tenable - still rather soft for the 'stabiliser legs' but workable so long as I don't cover the same ground twice or they sink in too far.
Now it's many years since I've worked a "180" wheeled excavator on stick controls, having been using my much smaller "360" tracked JCB 803 and I need to re-acquire the coordination skills of the stick controls as they are quite different from the servo joysticks of the little one.
I decided to start at the far end of the ditch where there was manoeuvring room.
Still for a first attempt it didn't go too badly - to try and make it easier for myself I positioned the machine at 90 degrees to the ditch so working the first bucket load is easy, however of course subsequent scoops have to be done slewing the boom so are no longer at 90 degrees, so neat edges aren't easy (or really possible without a tilting bucket, which I don't have). I managed to do about 33 foot of the first ditch in an hour and a half producing a huge pile of vegetation and a bit of silt - this will all have to drain and dry before I shift it to . . . well somewhere as yet not determined - - I hope that it shrinks considerably as it drys !
Now in the 33 foot I moved the machine three times. For my next go I will put the axis of the machine parallel to the ditch, slew the boom at 90 degrees and only take one bucket width before repositioning the machine. As it's parallel to the ditch it's only a case of driving forwards (well, legs up, 6 in 1 front bucket up, drive forwards then bucket down legs down and start again!)
No doubt by the end of this job I'll be quite good at it, but at the moment its a bit sketchy
![:bugeye:](https://madmodder.net/Smileys/default/confused0068.gif)