The Shop > Tools
Pultra 1750
vtsteam:
So is there a hole in the side of the bearing or bearing housing that the wick goes into? Tough to tell from the photos -- it just looks like a spaghetti spill. :poke:
Dell:
The picture is after I had fitted the wicks but before I trimmed them off , yes there is a 2mm hole in the bearings and about 1/2mm of the wick sticks out into the bearings and the other end of the wick just sits in the oil well, I am not sure how it works either but it must do because Pultra used that method of oiling for all there lathes even the 15/90 that looks identical to my lathe but about 4 times bigger.
Dell
vtsteam:
Thanks Dell. I'm sure it works I was just curious how it's routed. :beer:
Navigation
[0] Message Index
[*] Previous page
Go to full version