Hi
Just wondering if anyone uses a tailstock turret tool holder ? I`m looking at the arc euro stuff and I think it would be useful when doing ops such as drill and taping as I would usually use a centre drill then a taping drill then maybe a csk bit to give a lead in and then a taping guide along with the tap. This would be 4 tool changes and if doing say 5 or so of the same item the time adds up.
Just looking for any thoughts on the turrets - good, bad or otherwise. Also anyone know of a supplier for a Jacobs taper 2 to straight shank - around 12mm would be great ? I know I can make one failing all else.
Thanks for reading