Bee,
Interesting about the abs like resins. I've watched afew YouTube videos from cnc kitchen and tom salamandererer , both suggest increased strength, but i have wondered if this is just a sensitive resin and is better cured by the initial exposure?
I'll have to try the water washable stuff , it might be the best way to avoid excessive ipa exposure which is , i think , the worst problem. I know from experience that solvent exposure is nasty and non obvious ( blood pressure increases etc.) I noticed that a number of yt modellers have been using water based washing solutions (surfactants) instead of ipa . A hot wash in a big bath of percil might be worth a try8-)
Hi Joe,
You're right, correct orientation, is not obvious , and slightly counter intuitive , i.e , it seems, the best way to print flat is to mount the part at a compound angle !