| Gallery, Projects and General > Member Videos |
| Schaublin 125-CNC retrofit to LinuxCNC and Mesa cards. |
| << < (5/16) > >> |
| BillTodd:
Tip for pulling reluctant dowlpins , use an er collet chuck to grab the pin and threaded rod as a diy slide hammer. |
| awemawson:
And when you replace them always put one in with a female extractor thread - dead easy to do, and the next bloke to come along will thank you ! (Had that issue with the powered tooling gear boxes on my CNC lathe, making a female threaded dowel was the work of minutes on the lathe.) |
| RotarySMP:
Good points. I'll check if these are hardened, and if not I could drill and tap the end. |
| RotarySMP:
|
| RotarySMP:
Little more progress... |
| Navigation |
| Message Index |
| Next page |
| Previous page |