Gallery, Projects and General > Member Videos
My week this week, my workshop videos!
hermetic:
The workshop advances a tech level when we fit the new girdar trolley and get the chain hoist up, Rocker cover and other bits get painted, and I finally get onto the broken bolt in the front axle carrier casting, the results aren't good!! I hope persistence pays off!! I am posting this as parts 3 and 4 because I have shot over an hours worth of footage This week!
Phil Still hot in East Yorkshire.
hermetic:
Parts 5&6
I work on the air filter and pre cleaner, fix the dodgy handbrake, which has been a pain since I bought this tractor , and work towards the three point linkage removal, remove the tow hitch and link arms, and start to free them all off using the dreaded Blowlamp of death, alternately known as the Flamefast Brazing hearth! In part 6 (out now!) We continue with the air cleaner get the hydralic/transmission drained and the filter out, what a mess!!
Phil, Some rain, some shine, in the East York Shire!
hermetic:
Parts 7&8
Fordson Major rebuild, the hydraulics and rear transmission case. I removed the top cover, and realised there was 3" depth of black sludge in the bottom of the transmission case, and this had remained after 30 litres of "oil" was drained off! I set on cleaning it with kerosene, and by the end of day one I was beginning to see the castings, and the unmarked gears etc. Thankfully there seems to be no grit or metal in the sludge, as the fordson does have a good filter, and two magnetic plugs before the pump! We have a wander in the field, and get the 2cv tractor up there.....eventually!
Phil, thunderstorms and a wet start to the Harvest, in the East York Shire!
hermetic:
Work on the Fordson Major E1A continues. I bite the bullet and remove the PTO gearbox, and it is a good thing, because both it and the gearbox were full of black sludge, everything gets a good powerwashing out and we use the weldanuton technique to get a sheared bolt out! I put on overalls, and elbow length gloves!, it was hot, but it kept me more or less clean! Part 10 out now on my youtube page!
Phil, Some rain, some shine, in the East York Shire!
hermetic:
Fordson Major rebuild parts 11 and 12.
Rebuilding the hydraulic pump for the Fordson Major E1A. Not hard, but cleanliness and an O ring kit are essential, and patience, quite a bit of patience! Hydralic pump and most ancilliaries get refitted, and I add a hot gunk parts washer to my wish list! Part 12 available now at my youtube page Phil whitley, my week this week.
Phil,
August is the new September in the East York Shire!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version