Hi all,
Haven't been around much recently, but as the winter is approaching it is time to go in the shed, turn up the heat and make progress with the Fowler 4f loco.
So, I was machining a small block of aluminium on the Sieg. Switched it off, but it wouldn't re start.
It has been doing this on a number of occasions. It is running ok. Turn off the motor with the speed control, and when I try to start it again, nothing happens.
The green light is on.
I have checked the brushes, ok.
Looked inside the electronics box. no sign of any loose connections or burning etc.
I have had the machine for about five years, but it is very low mileage. Probably hasn't run for more than twenty/twenty five hours total. All very light work.
(I did notice that the motor pinion is an absolutely abysmal fit on the shaft. I'll have to do something about that)
Does anyone know what may be causing this problem ? Is it a 'stock' fault with these machines ?
Hope someone can help here.
Dave.