Gallery, Projects and General > Project Logs

my way to billd a stuart 10 horizontal engine

<< < (6/12) > >>

krv3000:
hi all I got a replacement cylinder for the Stuart so the other one im repairing to go on to my Stuart  v10 sos no pics of this bit but mild out the bad port section of the cylinder just bigger than  the valve chest that dune got sum cast iron and made a plug to fit in did this the old way with a hacksaw and files once a snug fit I glued it in place I have sum epoxy witch is resistant to hi temp once that's bin left for a week I will mill it and put the ports back in it right pics   

vtsteam:
Good idea about salvaging the old cylinder, Bob.  :thumbup: :clap:

krv3000:
hi well it ant bin a week lol I mild off the plug sos no pics of that bit then set the cylinder up in the 4 jaw chuck direst the end off then board our to 20mm then direst the opposite end off the bare in the pic its bang on 20mm that I have going threw the bore then marked out where the ports need to go  right pics   

vtsteam:
Those ports look a lot straighter than the old ones! And good job on the bore, Bob. I like seeing the pictures.  :thumbup: :beer:

Fergus OMore:
Hi Bob. Long time no see!

However, can you put a name to your high temperature epoxy resin please? Probably others are asking the same question.

Regards

Norman

Navigation

[0] Message Index

[#] Next page

[*] Previous page

Go to full version