Hi
The upgrade to pandora was a bit heart stopping. After inserting the flash drive and allowing a little time for the install the madmodder flash screen came up and then about 2 seconds later disappeared leaving a screen with light gray and white vertical lines. I then waited for about 10 mins in case it was going to do something else, but in the end I took the plunge and turned it on and off again. This time it powered up ok but with the DDCS4V2.1 splash screen. Once powered it displays ver: 2018-01-06-PDCNOR.
I did some further tests using a wireless keyboard plugged into the usb port. I was not able to map all of the keys but quite a few can be controlled in this way.
DDCSV 2.1 4 axis usb keyboard mapping
F3 = Moves x half distance toward zero
F9, / = tab key
F10 = sets sjr to 0.1 then 100%
8,f = highlights F
9,a,s = highlights S0,
g = selects gcode displayed, mach,g54 to g59.
Backspace, Tab = mode key, cont, step, mpg
↑ , 8 = Y+
↓ , 2 = Y-
→, 6 = X+
←, 4 = X-
PageUp , 9 = Z+
PageDn , 3 = Z-
- = run
Scroll Lock, - = enter
1 keypad = sets sro to 0
* = mode - cont, step, mpg
The wireless keyboard I used is not good enough for normal PC use, but the chip(s) may be hackable as a basis for a wireless pendant.
Best Regards
picclock