Gallery, Projects and General > How do I??

Rotary Table / Chuck Adaptor.

<< < (4/4)

DeereGuy:
David nice job, I did something similar to fit a 3" chuck on my 6 inch rotary table.  At present I am working on an adapter to fit my 3 jaw and 4 jaw 8" D1-4 to my rotary table.  I plan to use the D1-4 mount, by pretty much copying what is in the lathe spindle....wish me luck...

Stilldrillin:


--- Quote from: deere_x475guy on June 18, 2009, 07:07:37 PM ---David nice job, I did something similar to fit a 3" chuck on my 6 inch rotary table.  At present I am working on an adapter to fit my 3 jaw and 4 jaw 8" D1-4 to my rotary table.  I plan to use the D1-4 mount, by pretty much copying what is in the lathe spindle....wish me luck...

--- End quote ---

Thanks for that Bob!

Good luck to you mate.......  :thumbup:

Navigation

[0] Message Index

[*] Previous page