Gallery, Projects and General > How do I??

Rotary Table / Chuck Adaptor.

<< < (3/4) > >>

sbwhart:
Well done that man  :clap: it seems to be working out fine, pleased you found a use already for the little centre.

Stew

Stilldrillin:
I have finally finished this project & completed it`s first piece of work......  :wave:

Centre locating plug, tapped through 10mm for removal with chuck in situ, if necessary.




Countersunk chuck screws.
Why does Chester`s catalogue quote 63mm pcd........ When it is 66mm?  :scratch: They didn`t catch me out..... This time!  :D




Countersunk adaptor screws.....





To clear my faceplate.




Then I realised I will be tightening through the slots......  ::)




I fitted the assembly, then clocked a component in chuck jaws.
Within .0015, before tapping true & final tightening!

First job..... Drilling 1mm air holes in SEL steam engine wick holders.  :thumbup:






Just a bit pleased.....  :D

David D

bogstandard:

--- Quote ---Just a bit pleased..... 
--- End quote ---

So you should be David.

Very nice job, plus you have added another string to your bow, and a little more workshop tooling. :thumbup: :clap:


John

sbwhart:
Nicely done and shown David  :thumbup:

It certainly is an advantage being able to fit you're chuck to the RT.

Have fun  :D

Stew

Darren:
They look very nicely done David,

Now I know how I'm going to tackle one of my little engine tasks  :thumbup:

Navigation

[0] Message Index

[#] Next page

[*] Previous page