The Shop > CNC |
My desktop CNC router's first cuts |
<< < (2/3) > >> |
NeoTech:
If i rememer correctly those machines were called "lillasyster" mening "Little sister" - where quite popular on the other forum and one of the earliest home built cnc machines i can actually remember. =) |
MadModder:
Yes, you are absolutely right, my fellow moderator. ;) The project threads for them were still quite active when you registered there back in '08. |
Biggles:
The construction drawings or supplier and the electronics would be helpful in reconstructing a duplicate. :dremel: |
MadModder:
Well, as I implied by the "RIP", the supplier has gone west, faded away, and assumed room temperature. Nobody has taken over. I believe a nephew of his helped with the cleaning of the house and has all the equipment in possession, but nobody has heard anything from him ever since. So, I guess the information is lost. I don't have the mechanical drawings. I don't have the schematics for the motor drivers (plug-in modules) This will be so much fun the day the magic smoke lets itself out... I do have the schematic for the break out board though, that the motor driver modules mount onto. I just have to convert it from Orcad to Altium. It may work well, i hope... :scratch: |
Biggles:
OK Modder, hope it doesnt also go west. :Doh: |
Navigation |
Message Index |
Next page |
Previous page |