The Shop > CNC
Desktop Mill CNC Conversion
lesterhawksby:
I'm somewhat embarrassed by how rough that thing is. I did try to warn Joules how bad the horizontal was!
(I only used it as a vertical and, actually, it cut some fairly smooth and square surfaces for me on small parts despite the poor contact Joules has discovered - I never stripped it down and built it up properly when I got it - but I spotted the horizontal problem early and fixing it is beyond me. Various misadventures in outside-the-shop life prevented me from taking it back when I first found out)
Navigation
[0] Message Index
[*] Previous page
Go to full version