Gallery, Projects and General > Project Logs
Wilson's Workshop Waffle
RobWilson:
--- Quote from: Will_D on October 06, 2016, 06:57:27 PM ---Love that the "MAX RPM" is unspecified!
A bit like "Max Headroom"
--- End quote ---
:lol: aye it is a bit random Will ,especially as its a fixed speed motor :scratch:
Rob
RobWilson:
Afternoon Lads
Well I picked up a couple more incidentals for the shop this morning , I had a wee run South to Pontefract and came back with these :drool:
A rather tidy 10" Elliott rotary table for the Bridgeport .
and an Auto reversing tapping head for the Arborga drilling machine
Rob :dremel:
awemawson:
Did you win the lottery then Rob :scratch:
RobWilson:
--- Quote from: awemawson on October 08, 2016, 09:34:32 AM ---Did you win the lottery then Rob :scratch:
--- End quote ---
Nope just good at hunting out a bargain ,,,,,,,,,,or three Andrew :)
Rob
RobWilson:
Evening Lads
A wee bit product review :dremel:
I had a job on today that required the relocation of a couple of holes in a hydraulic pump flange and a bracket , pump needed to be rotated about 10 degrees so that the suction hose would not foul the engine sump .
The pump is located in a fairly confined space , so I cracked out the transfer screws I purchased wile at Arceurotrade a few weeks back .
The kits come in two ranges 3mm - 6mm & 6mm - 12mm
The M8 and M12 saved the day :thumbup: .
Each kits come with a driver to fit and remove the transfer screws .
Just the job :dremel:
Rob
http://www.arceurotrade.co.uk/Catalogue/Measurement/Punches-Scribes/Transfer-Screws
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version