Gallery, Projects and General > Project Logs
Wilson's Workshop Waffle
Mayhem:
--- Quote from: RobWilson on August 14, 2016, 12:59:39 PM ---...its a tad worse for wear and needs some Wilson loving...
--- End quote ---
I thought this was a family-friendly web site :bugeye:
vintageandclassicrepairs:
Hi Rob,
I was doing a bit to the Colchester over the last few days
As you are intending to do mine has been located with its back to a wall
I believe theres room for the coolant tank to sit on the floor behind the front panel between the pedestals
It will take a bit of reorganising of the drain from the swarf tray though !!!
I'm thinking of some sort of bund tray to sit the tank and pump into ??
I made a novice mistake where I mounted the oil filter unit :doh:
I had not looked at the back of the big end cover to see theres a dividing partition between the belts and the gear train :bang:
I will have to drill mounting holes for a bracket in the cast iron and reposition the unit low down
John
RobWilson:
Hi John
I got the lathe moved into the workshop at the weekend and was looking at the coolant tank access problem ,and I may just transfer the rear coolant access cut out to the front of the leg ,using the rear access cover on the front .
I will also have to re mount the Y axis DRO scale as it sticks straight out from the saddle . All fun and games .
Cheers Rob
awemawson:
On my Master 2500 when it was against the wall at my last place, I truncated (cut & shut) the tank so I could just squeeze it in and out.
RobWilson:
In other news I did happen across a rather nice (well i think so ) set of angle blocks , hardened and ground ,in 5 degree increments ,5/8 thick should be a handy addition to the shop :dremel:
Rob
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version