Using DDCSV1.1 in inch mode?
I am in the middle of switching from Mach 3 to this device and am missing something about the inch programming mode.
I have used Fusion 360 and Jay's post processor to generate the code below with a G20 for inch mode. it is the outside contour of a rectangle.
The DDCSV1.1 display is not matching up with the program coordinates.
I have attached my setup vars for ref. ( Thanks to Benedikt for the configuration utility and firmware!)
Andy Olney
Here is a photo:
https://goo.gl/photos/KK77kqJdbG5xELAF7(Program: outside)
(test)
(Toolpath: 2D Contour2)
(Units: inches)
(Tool: bullnose end mill, D=0.250 CR=0.015)
(Workpiece: -1.293 <= X <= 1.293 | -0.789 <= Y <= 0.789 | -0.290 <= Z <= 0.000)
(Tool travel: -1.378 <= X <= 1.378 | -0.949 <= Y <= 0.874 | -0.040 <= Z <= 0.600)
(Safe Z: 15.240)
G90
G20
G64 P0.001
G00 Z15.240
S 1000
M03
(--- 2D Contour2 ---)
S 1000
G00 X1.278 Y-0.949 Z0.600
G00 X1.278 Y-0.949 Z0.200
G01 X1.278 Y-0.949 Z0.039 F60
G01 X1.278 Y-0.949 Z-0.015 F30
G01 X1.278 Y-0.946 Z-0.028
G01 X1.278 Y-0.936 Z-0.037
G01 X1.278 Y-0.924 Z-0.040
G01 X1.278 Y-0.899 Z-0.040 F60
G03 X1.253 Y-0.874 Z-0.040 I-0.025 J0.000
G01 X-1.253 Y-0.874 Z-0.040
G02 X-1.378 Y-0.749 Z-0.040 I0.000 J0.125
G01 X-1.378 Y0.749 Z-0.040
G02 X-1.253 Y0.874 Z-0.040 I0.125 J0.000
G01 X1.253 Y0.874 Z-0.040
G02 X1.378 Y0.749 Z-0.040 I0.000 J-0.125
G01 X1.378 Y-0.749 Z-0.040
G02 X1.253 Y-0.874 Z-0.040 I-0.125 J0.000
G03 X1.228 Y-0.899 Z-0.040 I0.000 J-0.025
G01 X1.228 Y-0.924 Z-0.040
G01 X1.228 Y-0.936 Z-0.037
G01 X1.228 Y-0.946 Z-0.028
G01 X1.228 Y-0.949 Z-0.015
G00 X1.228 Y-0.949 Z0.600
G00 Z15.240
M5
M2