| The Shop > CNC |
| DDCSV1.1 4 Axis controller |
| << < (168/202) > >> |
| WeldingRod:
There is a setting in there for where to probe. You probably want "current". I finally got limit switches hooked up! I'm trying to home with the hard limit switches, which might be a bad idea... When I home the axis it goes the way I want it to go and homes, THEN it runs off and tags the OTHER limit. That sounds like your problem. Is there a setting to stop this? I'm tempted to try hooking the hard limit to the home switch inputs to see what happens. And also try just wiring the home switch inputs. Sent from my SAMSUNG-SM-G891A using Tapatalk |
| dale brisson:
anyone got the 4th axis running? i dont know how to figure it all out.looking for info driver is set to 1600 200 steps on motor 6:1 gearing how do i set pulse/degree and is there anything else i have to change in the ddcsv? :bang: |
| philf:
--- Quote from: dale brisson on January 23, 2018, 01:27:55 PM ---anyone got the 4th axis running? i dont know how to figure it all out.looking for info driver is set to 1600 200 steps on motor 6:1 gearing how do i set pulse/degree and is there anything else i have to change in the ddcsv? :bang: --- End quote --- (1,600 * 6)/360 = 26.6666666........................ Phil |
| WeldingRod:
--- Quote from: philf on January 23, 2018, 01:32:53 PM --- --- Quote from: dale brisson on January 23, 2018, 01:27:55 PM ---anyone got the 4th axis running? i dont know how to figure it all out.looking for info driver is set to 1600 200 steps on motor 6:1 gearing how do i set pulse/degree and is there anything else i have to change in the ddcsv? :bang: --- End quote --- (1,600 * 6)/360 = 26.6666666........................ Phil --- End quote --- You need to enable it. The other big thing is you need to set the "log radius" to something where you don't loose steps. I have one running. Almost ready to cut on it. Sent from my SAMSUNG-SM-G891A using Tapatalk |
| dale brisson:
--- Quote from: dale brisson on January 23, 2018, 01:27:55 PM ---anyone got the 4th axis running? i dont know how to figure it all out.looking for info driver is set to 1600 200 steps on motor 6:1 gearing how do i set pulse/degree and is there anything else i have to change in the ddcsv? :bang: --- End quote --- never mind got it when setting the pulse ddcsv will not allow you to go under 00050.00 so had to up the driver microsteps |
| Navigation |
| Message Index |
| Next page |
| Previous page |