The Shop > CNC |
DDCSV1.1 4 Axis controller |
<< < (157/202) > >> |
philf:
Dale, If your stepper driver is set to 1,600 steps per rev and you have a 16mm pitch leadscrew then the pulses per mm is simply 1,600/16 = 100 pulses/mm. Your resolution would be 0.01mm. 16mm is a heck of a pitch for a 16 diameter ball screw - they're normally 5 or 10 mm pitch. At 16mm pitch you'll need powerful steppers to drive the table and also to resist cutting forces. Phil. |
dale brisson:
ive had theses ball screws for year + with 1800 oz motors ya there big fast lots of power the ball screw is 1616 16mm pre rev 16mm diameter thanks philf just need to figure the vfd i hate doing it by hand on/off speed etc.. i want the software to do it |
philf:
Hi Dale, I haven't got a DDCSV controller - I use Mach3. I'm sure someone out there will know. Phil. |
dale brisson:
( hey philf) i also have a mach3 (bob) but cant get mach3 to run on windows 10 so right now im stuck using cheap uno board running grbl. so i bought the ddscv1.1 in hopes to just use the kinda vfd i have work :doh: |
Benedikt:
--- Quote from: dale brisson on December 02, 2017, 01:19:34 PM ---( hey philf) i also have a mach3 (bob) but cant get mach3 to run on windows 10 so right now im stuck using cheap uno board running grbl. so i bought the ddscv1.1 in hopes to just use the kinda vfd i have work :doh: --- End quote --- I actually came from grbl too and later upgraded to the DDCSV1.1. However, I have in the meantime switched back to grbl and a mini Windows 8.1 PC. I found a touchscreen that matched the hole I cut into the front panel and then designed a 3D printed holder for the display. It's working quite well so far. The reason, I went back is that my original DDCSV1.1 broke down during bootloader development and I had to order a new one from China. Two lost shipments later, I got refunded and many months had passed. Since I had to get my CNC up and running again, I settled for a better grbl based controller along the setup described above. Best regards, Benedikt |
Navigation |
Message Index |
Next page |
Previous page |