| The Shop > CNC |
| DDCSV1.1 4 Axis controller |
| << < (139/202) > >> |
| blades:
Easy. Basically, just ignore any setting that references MM, and treat it as inches. Just watch the default rapid & feed rates, which are too high for inches per minute. |
| zenbot:
when I tried that, it lost .001 inches for every inch I jogged. the readout would start out 0, then .999, the 1.998, the 2.997, etc. |
| johnsattuk:
I want to use my controller on a new project and have reached the testng stage, everything worked manually as expected, however it ran very roughly on an actual program, took a while and some test programs to discover that it does not like I & J codes. :doh: The literature says that it does, is this something that has got broken in the 'plus' version or has it always been this way or is just my controller. |
| johnsattuk:
Don't know what i've done but seems to be working OK at the moment :Doh: |
| tom osselton:
You told someone about the problem you will never see that again! :D |
| Navigation |
| Message Index |
| Next page |
| Previous page |