| The Shop > CNC |
| DDCSV1.1 4 Axis controller |
| << < (138/202) > >> |
| old Zozo:
--- Quote from: TurboRexed on September 17, 2017, 07:33:39 AM ---What is your x and y axis mm/1rev ? and can your driver do microstepping? --- End quote --- I use trapezoid screw, pitch of all axis is is 6.35mm/rev. Driver type is DM556D , microsteps are from 1/2 to 1/128. ( "...buggered..." - this should not have been ) |
| TurboRexed:
--- Quote from: old Zozo on September 17, 2017, 10:27:44 AM ---I use trapezoid screw, pitch of all axis is is 6.35mm/rev. Driver type is DM556D , microsteps are from 1/2 to 1/128. ( "...buggered..." -??? :hammer: ) --- End quote --- No this sounds perfect, if all your motors are 200 steps per rev, I would set the microstepping dip switches for all axis to 10, thus "sw5-sw6-sw7-sw8" must be "off-on-on-off". This will make them run quiet and still have some good torque available, but in theory you can make the microstepping any setting as long as they are the same for all your axis on this machine. |
| groszek:
Hi all For more than a year I have used the RMHV2.1 controller with original software. As for my modeling needs, it is ok. However, during this time there were some problems that I hope with your help will solve. 1. I made a touch probe, and set up with the manual but after changing the parameters and pressing the key1, nothing happens. # 446 function of External key 1: find center. Did anyone run this function? 2. Has anyone managed to use the diameter and height adjustments available in the parameters? |
| blades:
--- Quote from: zenbot on September 15, 2017, 01:54:34 PM ---will the new version support inches? --- End quote --- It is exciting news that a new version is on the horizon, and I for one can't wait to see it! With regards to your question if it supports inches, I also hope it does, as I primarily work in inches. That said, I have set up & run my controller in inches, and it seems to work just fine that way. I really think the controller's firmware should be set up more generically in "units" since it can support either, and not assume mm specifically. |
| zenbot:
How did you do that? --- Quote from: blades on October 15, 2017, 03:40:56 PM --- --- Quote from: zenbot on September 15, 2017, 01:54:34 PM ---will the new version support inches? --- End quote --- It is exciting news that a new version is on the horizon, and I for one can't wait to see it! With regards to your question if it supports inches, I also hope it does, as I primarily work in inches. That said, I have set up & run my controller in inches, and it seems to work just fine that way. I really think the controller's firmware should be set up more generically in "units" since it can support either, and not assume mm specifically. --- End quote --- |
| Navigation |
| Message Index |
| Next page |
| Previous page |