| The Shop > CNC |
| DDCSV1.1 4 Axis controller |
| << < (80/202) > >> |
| johnsattuk:
Can you give his PayPal account, I will send him a donation, the Paypal acct is this one annette.muessig@gmail.com, I haven't sent anything yet, but I intend to' [/quote] Thanks, have donated 40 euro. |
| BrokenEye:
:zap: I just sent him the same amount 40 Euro |
| johnsattuk:
:thumbup: |
| Benedikt:
Hello! I can't say it enough: Thank you all so much! This really helps a lot. :thumbup: :mmr: :nrocks: |
| BrokenEye:
--- Quote from: Avis on February 19, 2017, 10:22:17 AM ---Hello, in the DDcsv1, a very low beep sounds when the limit switch is activated, there would be some way to amplify that beep. Greetings. --- End quote --- mine still had the paper label stuck to the buzzer , you could check that first , and obviously peeling it off :D |
| Navigation |
| Message Index |
| Next page |
| Previous page |