| The Shop > CNC |
| DDCSV1.1 4 Axis controller |
| << < (73/202) > >> |
| chriscnc:
Thanks so much for the configurator.... quick question since it does not support tool change , why does it have all the tool offset settings? i thought you make new code for each tool and just re zero the z... but if it has tool offsets can't i run multiple tools in one code so i can use rest machining? |
| Will_D:
Not much progress as have been a bit unwell! Hello Benedikt, good to hear from you again, Thanks for the configuator. So its obvious my controller is out of date [2016-05-11-73-NOR] as there is no mention of parameter #395 "Allow G53" So what does this do? Regards my problem with the code stopping I really suspect its the controller and or its software or parameters. The code works on another controller and on g-code simulators Who has the latest version? |
| Merlin201314:
I will post the firmware I have in my controller, but you can download it from benedikt site, is up to date Inviato dal mio iPad utilizzando Tapatalk |
| Benedikt:
--- Quote from: Will_D on February 08, 2017, 07:59:02 AM ---Not much progress as have been a bit unwell! Hello Benedikt, good to hear from you again, Thanks for the configuator. So its obvious my controller is out of date [2016-05-11-73-NOR] as there is no mention of parameter #395 "Allow G53" So what does this do? Regards my problem with the code stopping I really suspect its the controller and or its software or parameters. The code works on another controller and on g-code simulators Who has the latest version? --- End quote --- You can download the latest version from here: https://bmuessig.eu/secure/data/CNC/DDCSV11/install-mod-20161119.zip To install it, just unzip it to a blank, FAT32 formatted stick and reboot the controller with the stick inserted. Now wait until the home screen is shown again. The controller might reboot once to finish the upgrade. I will finish some things up and release a 2017 version soon, so stay tuned :) --- Quote from: chriscnc on February 08, 2017, 12:54:49 AM ---Thanks so much for the configurator.... quick question since it does not support tool change , why does it have all the tool offset settings? i thought you make new code for each tool and just re zero the z... but if it has tool offsets can't i run multiple tools in one code so i can use rest machining? --- End quote --- I think it has a manual tool change. So it knows the offsets, but the tool has to be changed by oneself. It will probably just pause until the tool is changed. Thanks for all the positive feedback so far :) |
| Merlin201314:
I agree about the manual tool change, but how to trigger the pause and tell him which tool we need? Inviato dal mio iPad utilizzando Tapatalk |
| Navigation |
| Message Index |
| Next page |
| Previous page |