DDCSV1.1 4 Axis controller

The Shop > CNC

<< < (44/202) > >>

Benedikt:
Thanks a lot for all the input :thumbup:

So how about Pandora MMCNC?

Still a nice name, awemawson!

Best of both :borg:

Merlin201314:
We could use the MMCNC for the controller and the Pandora for the software no?
I'll send you a splash sample in a few minutes

Benedikt:

--- Quote from: Merlin201314 on November 20, 2016, 10:13:30 AM ---Benedikt, i am quite happy to sacrifice my controller if you want to go for a complete different way,

Have a look at this link, is not the program, is all the dependencies in python to have a look, including the GUI toolkit "tkinter"
https://github.com/vlachoudis/bCNC
Here you have the link,
I had downloaded this program as i own 2 "smoothieboard 5 axis", and i use them for my printers "32 bit processor obviously" then i decided to buy the stand alone controller instead to install everything on a raspberry pi3
Hope that can help a bit, let me know your opinion please
Emanuel

--- End quote ---
Well I wouldn't mind naming it as you suggested.
Let's see what the other members think then we decide on a name.

Your idea sounds good and if I had known this a few months earlier, I wouldn't have bought a DDCSV1.1MMCNC.
But we'll stick with what we have. About the program, I don't know if porting it is possible. It might be worth a try, but remember, we still need to find out how the motion driver works and how we can communicate with it.
Unfortunately nobody here has an ARMv5 capable version of IDA or anything remotely similar to disassemble (and possibly turn back into C code to make it at least a little bit easier to understand) the attached file. :(

Merlin201314:
Here you have a sample, is open to any suggestion of course :thumbup:

Will_D:
That would float my boat.

Lovely image!

Just as an aside: Wasn't the idea behind Pandora's Box was NOT to open it?

It may after all contain Schroedinger's Cat!!

Navigation

 Message Index

Go to full version