Hi All,
The other day while threading by pushing the die holder with the tail-stock and cranking by hand I noticed that the lathe wanted to run forward as I reversed direction to remove the die.
Anyway, this prompted me to do some checking.
1) With the chuck jaws screwed in so I had a smooth surface, Speed controller to the off position, try turning the chuck in both directions. Result, more resistance going against the direction of the fwd/rev toggle.
2) Repeat with the machine set to reverse, result, same as 1).
3) Repeat 1&2 except put the Fwd/Rev Switch in neutral. Result, Free either way.
4) Repeat all of the above but with the emergency stop button engaged, Result, Free either way.
This leads me to conclude that there is definitely power to the motor and the Speed controller off is not actually off off, just not enough power to run the motor. (I thought there was a definite off position as there is a definite click at the zero position, evidently not on my machine.)
![:zap:](https://madmodder.net/Smileys/default/electricf.gif)
Were I fiddling about within the control box or any of the electrics I would automatically pull the plug from the power outlet. We are on 240V ac here in OZ.
Anyone else have this problem, or is it just my Clone?
OK, perhaps I should have turned the machine off at the power point rather than just turn the speed dial to off when hand threading. In future the emergency stop will be pressed as it locks all power so no
![:zap:](https://madmodder.net/Smileys/default/electricf.gif)
.
John B