Home Base > Introductions

Hi there from yet another newbie

<< < (3/4) > >>

Bernd:
Tim,

Elmers #25 Wobbler was my first engine build. A fun engine to make and very easy.




But there are lots of choices out there.

Regards
Bernd

spuddevans:
Thanks for the suggestion Bogs,


--- Quote from: Bernd on May 04, 2009, 08:47:42 AM ---Tim,

Elmers #25 Wobbler was my first engine build. A fun engine to make and very easy.




But there are lots of choices out there.

Regards
Bernd


--- End quote ---

I'm leaning towards that one myself. Does anyone forsee any problems as I dont yet have any silver solder gear, I just have low temp solder. I notice from the plans that there seems only to be one SS joint on it in the cylinder pivot pin, could I locktite it instead? or would the low temp (plumbers stuff) solder do?


Tim

Bernd:
Tim,

I didn't use any type of solder or Loctite. I made the hole a press fit for the pin. Hasn't fallen out yet.

I did a build sequence and have it on my web site at The Model Engine Shop

Enjoy.

Bernd

spuddevans:
Thanks Bernd, that link gives me a good reference to read over.



Tim

Stilldrillin:
Welcome Tim,

It`s nice `ere......  :wave:

Get stuck in and enjoy it!  :thumbup:

David D

Navigation

[0] Message Index

[#] Next page

[*] Previous page