Gallery, Projects and General > Project Logs
a eclipse pin chuck sensertive drill atachment
philf:
--- Quote from: John Rudd on January 11, 2016, 05:59:11 AM ---
--- Quote from: krv3000 on January 10, 2016, 05:33:37 PM ---
o and I had to stop for me tee see last pic
--- End quote ---
I wondered why you were showing us your sandwich.... :lol:
Nicely done Bob....think I might have to make one myself... :dremel:
--- End quote ---
Make what - a sandwich?
Joking aside they're a very nice accessory for drilling small holes. You can feel the pressure better and pecking at the hole is much easier and quicker than having to turn a handwheel back and forth.
Mine uses a ball spine out of a scrap non-rotating air cylinder so there's no noticeable friction.
:beer:
Phil.
krv3000:
hi all thanks for the comments was going to do a bit more tonight but its freezing as for the set up tool no I did not make it I got it given but it needed my loving touch if and when I get a mill I plan on remaking it
Pete49:
good vegetarian meal there Bob. Mine was vegetarian ham and salad. :lol: Oh the metal work was up to your usual standards Bob very nice. I have spent a frustrating morning trying (and failing) to replace a part that came out of my dial calliper when I pulled it apart :doh: Its over 40C again today so back under the ac for the rest of it. No I don't want your cold, stormy weather thanks all the same.
Pete
mechman48:
krv3000
Nicely made little tool' they sell them on e bay & other suppler sites but are silly money. Talking about offset taper turning, I made something similar some years ago, have only used it once in anger since...
Fergus OMore:
Yesterday, went out on the spending spree for a local Myford ME10 which was described as 'An ideal Starter lathe' and I found both the tailstock stock thing and the set over one in the box of goodies.
The other goodies included a Potts drilling spindle and a Cleeve swing tool holder along with a QCTP and rear parting tool post.
So it's nice to see what you have done.
Cheers
Norman
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version