Gallery, Projects and General > Project Logs
a eclipse pin chuck sensertive drill atachment
jb3cx:
I guess you must have been shopping in and around the jarrow area Norman ,
Peter ,
Fergus OMore:
Peter,
Quite correct!
Came with lots of 'goodies' which could go on my Super7B if it isn't too damaged after the storms and winter are over. Nice Potts spindle and a Cleeve swing tool as bonuses
Regards
Norman
Xldevil:
--- Quote from: mechman48 on January 12, 2016, 09:20:51 AM ---krv3000
Nicely made little tool' they sell them on e bay & other suppler sites but are silly money. Talking about offset taper turning, I made something similar some years ago, have only used it once in anger since...
--- End quote ---
Made something similar ,using Hemingway-Kits set.
http://www.hemingwaykits.com/acatalog/Set_over_Centre.html
I use it when ever I need a taper.
Very handy tool,IMHO.
Fergus OMore:
Mine is calibrated to show offsets for 1 to 3 Morse Taper. Came in the boxes of goodies with the ME10. Complete in its own box and looking rather superior to my usual selection of what I laughing regard as tooling.
Norman
rotorhead:
Hi Bob,
Good to see the project you've been busy with, I like the sensitive drilling spindle idea, I'll have to incorporate it into my sensitive die/tap holder musings...
I want to thread male & female M5 x 0.5, for that dial gauge needle puller I promised, sorry it's taking so long...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version