| Gallery, Projects and General > Project Logs |
| a eclipse pin chuck sensertive drill atachment |
| << < (2/5) > >> |
| philf:
--- Quote from: John Rudd on January 11, 2016, 05:59:11 AM --- --- Quote from: krv3000 on January 10, 2016, 05:33:37 PM --- o and I had to stop for me tee see last pic --- End quote --- I wondered why you were showing us your sandwich.... :lol: Nicely done Bob....think I might have to make one myself... :dremel: --- End quote --- Make what - a sandwich? Joking aside they're a very nice accessory for drilling small holes. You can feel the pressure better and pecking at the hole is much easier and quicker than having to turn a handwheel back and forth. Mine uses a ball spine out of a scrap non-rotating air cylinder so there's no noticeable friction. :beer: Phil. |
| krv3000:
hi all thanks for the comments was going to do a bit more tonight but its freezing as for the set up tool no I did not make it I got it given but it needed my loving touch if and when I get a mill I plan on remaking it |
| Pete49:
good vegetarian meal there Bob. Mine was vegetarian ham and salad. :lol: Oh the metal work was up to your usual standards Bob very nice. I have spent a frustrating morning trying (and failing) to replace a part that came out of my dial calliper when I pulled it apart :doh: Its over 40C again today so back under the ac for the rest of it. No I don't want your cold, stormy weather thanks all the same. Pete |
| mechman48:
krv3000 Nicely made little tool' they sell them on e bay & other suppler sites but are silly money. Talking about offset taper turning, I made something similar some years ago, have only used it once in anger since... |
| Fergus OMore:
Yesterday, went out on the spending spree for a local Myford ME10 which was described as 'An ideal Starter lathe' and I found both the tailstock stock thing and the set over one in the box of goodies. The other goodies included a Potts drilling spindle and a Cleeve swing tool holder along with a QCTP and rear parting tool post. So it's nice to see what you have done. Cheers Norman |
| Navigation |
| Message Index |
| Next page |
| Previous page |