| Gallery, Projects and General > Project Logs |
| a eclipse pin chuck sensertive drill atachment |
| << < (3/5) > >> |
| jb3cx:
I guess you must have been shopping in and around the jarrow area Norman , Peter , |
| Fergus OMore:
Peter, Quite correct! Came with lots of 'goodies' which could go on my Super7B if it isn't too damaged after the storms and winter are over. Nice Potts spindle and a Cleeve swing tool as bonuses Regards Norman |
| Xldevil:
--- Quote from: mechman48 on January 12, 2016, 09:20:51 AM ---krv3000 Nicely made little tool' they sell them on e bay & other suppler sites but are silly money. Talking about offset taper turning, I made something similar some years ago, have only used it once in anger since... --- End quote --- Made something similar ,using Hemingway-Kits set. http://www.hemingwaykits.com/acatalog/Set_over_Centre.html I use it when ever I need a taper. Very handy tool,IMHO. |
| Fergus OMore:
Mine is calibrated to show offsets for 1 to 3 Morse Taper. Came in the boxes of goodies with the ME10. Complete in its own box and looking rather superior to my usual selection of what I laughing regard as tooling. Norman |
| rotorhead:
Hi Bob, Good to see the project you've been busy with, I like the sensitive drilling spindle idea, I'll have to incorporate it into my sensitive die/tap holder musings... I want to thread male & female M5 x 0.5, for that dial gauge needle puller I promised, sorry it's taking so long... |
| Navigation |
| Message Index |
| Next page |
| Previous page |