FACE PLATE WORK HOLDING AWKWARD OBJECTS

Gallery, Projects and General > Neat Stuff

<< < (2/3) > >>

seadog:
David, the images are a little too large. if you scroll to the right you'll see the second clamp block.
Graham

mexican jon:

--- Quote from: DavidA on December 27, 2015, 01:12:44 PM ---Seadog,

Where is the second one ?

And Anthony wrote...

...The slots in the one clamp allow the pressure to be applied perpendicular to the job via the grub screws . The other block clamps are just buttress blocks,..

I did expect to see two, but can only find one; that's why I queried it.

Dave

--- End quote ---

I had to click on the picture then look at the others in his photo bucket account before I could see the other 1 :Doh: the picture doesn't seem to be here :doh: just on photo bucket :hammer:

DavidA:
Mexican Jon, Seadog,

That would account for it. I assume it must be the mostly hidden clamp behind the thick vertical web.

But definitely a 'must make' item.

Dave.

mcostello:
The most awkward item I had to ever had to put in a lathe was a regulation Bowling Ball. It had to have a piece parted off for a lid for an art project.

nrml:
If there is still any confusion, Mr Hall's drawings for the clamps freely available on his website will clear it up. http://www.homews.co.uk/LPClSim01.pdf
His website is well worth bookmarking. It is full of very useful and interesting stuff.

Navigation

 Message Index

Go to full version