Gallery, Projects and General > The Design Shop

3D Printed Quorn Tool & Cutter Grinder

<< < (3/24) > >>

mattinker:
I may be being somewhat of a wet blanket, but why would your individual know what a Quorn was? With his limited machines what use would he have for a Quorn. He could of course look at the Bonelle, it uses steel stock and no weldments.

Regards, Matthew

Joules:
As I will be printing in PLA this will actually be a Corn based Quorn   :bugeye:

RotarySMP:
Precision ground shaft is cheap. Dont waste your time looking for an alternative. 3d print the caasting parts with minimal infill, then lost PLA cast them in iron.
Mark

Joules:
Matthew, he spotted one on the internet when he went hunting to find out why all his blunt tools wouldn't work.   Whilst he was search he found some MAD old fool in 2016 made one out of PLASTIC !!! on a then 3D printer and he left all his plans for others to try.    :thumbup:

awemawson:
"Whilst he was search he found some MAD old fool in 2016 made one out of PLASTIC !!!"



Blimey, as well as not welding he must be psychic - can he tell me what else is going to happen in 2016  :lol: :lol:

Navigation

[0] Message Index

[#] Next page

[*] Previous page