The Shop > Metal Stuff
Wanted: Perforated Zinc sheet
awemawson:
--- Quote from: vtsteam on August 02, 2015, 03:14:35 PM ---Andrew, what about using a BMW as a sacrificial anode?
--- End quote ---
OK I'll fess up :lol:
I was going to do a bodge bondo repair on the JCB 803 windscreen frame where it has rusted away to zilch in one place where the wiper arm parks. Most is covered by the window seal which is what has held the water hence the rust. But I've shamed myself into doing a proper job.
Although it originally was 3 mm thick plate so easy to weld a bit in, it's in a confoundedly difficult place to get at. Been doing some experimental welds this evening and I reckon I can just about get at it with a long stick out and turning the gas up (outside welding)
Fergus OMore:
So you are running TWO posts here for one repair, Eh? :bang:
To err is human, to forgive -Divine.
Norm
awemawson:
--- Quote from: Fergus OMore on August 02, 2015, 04:39:45 PM ---
So you are running TWO posts here for one repair, Eh? :bang:
To err is human, to forgive -Divine.
Norm
--- End quote ---
If it works ok I'll post it in the JCB thread, otherwise it'll get covered in bondo and lost :lol:
Pete W.:
Hi there, Andrew,
I think I have some. The question is 'WHERE?'!!!!!!!!!!!!!!!!!!! :scratch: :scratch: :scratch: :scratch: :scratch: :scratch:
I'll have a search later this morning and PM you if I find it.
awemawson:
Thanks Pete but the need has passed. See the JCB 803 thread for details :thumbup:
Navigation
[0] Message Index
[*] Previous page
Go to full version