« previous next »
Pages: [1]   Go Down

Author Topic: Laser Cutting SS  (Read 2604 times)

Offline Will_D

  • Hero Member
  • *****
  • Posts: 668
  • Country: ie
    • National Homebrew Club of Ireland
Laser Cutting SS
« on: June 01, 2015, 03:58:19 PM »
Anyone any first hand experience of what the state of the art laser cutters do on thin (0.7 - 1.0mm ) stainless sheet?

I would hope for a very clean edge but what about colouration of the cut edges?

Is it a one step process from raw to finished item?

MTIA  :beer:
Logged
Engineer and Chemist to the NHC.ie
http://www.nationalhomebrewclub.ie/forum/

Offline John Stevenson

  • In Memoriam
  • Hero Member
  • *****
  • Posts: 1643
  • Nottingham, England.
Re: Laser Cutting SS
« Reply #1 on: June 01, 2015, 06:42:58 PM »
Yes, they make a marvellous job at these thickness's.
They cut SS with nitrogen so stop surface cracks and so there is no discolouration at all, the cut edge is silver shiny.
Logged
John Stevenson

Offline Will_D

  • Hero Member
  • *****
  • Posts: 668
  • Country: ie
    • National Homebrew Club of Ireland
Re: Laser Cutting SS
« Reply #2 on: June 02, 2015, 04:58:10 AM »
Thanks John for the reply!

In response its "Oh Bugger, This project is go and so its going to cost me money now"
Logged
Engineer and Chemist to the NHC.ie
http://www.nationalhomebrewclub.ie/forum/

Offline redshift

  • Jr. Member
  • **
  • Posts: 47
Re: Laser Cutting SS
« Reply #3 on: June 02, 2015, 07:09:19 AM »
Here is a picture of some 1mm stainless which  we cut at work, it was cut on a 4kw Trumpf 3030.
If you need more info / help just ask
Regards,
Dave
Logged
Pages: [1]   Go Up
« previous next »