« previous next »
Pages: [1]   Go Down

Author Topic: Parting Off Tool Made From 1/64" Slitting Saw  (Read 3826 times)

Offline sbwhart

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3530
  • Country: gb
  • Smile, Be Happy, Have Fun and Rock Until you Drop
Parting Off Tool Made From 1/64" Slitting Saw
« on: March 26, 2015, 12:00:36 PM »
I though I'd do a video of the parting tool I made to make some spacers for the tiny Engine I just finished off. I had trouble parting off with my normal 1/16" parting tool it just bent the thin bar so I made this tool it's not my Original idea I saw it some ware can't remember ware.

Stew

     


« Last Edit: March 26, 2015, 12:27:35 PM by dsquire »
Logged
A little bit of clearance never got in the road
 :wave:

Location:- Crewe Cheshire

Offline John Rudd

  • Hero Member
  • *****
  • Posts: 2532
  • Country: gb
Re: Parting Off Tool Made From 1/64" Slitting Saw
« Reply #1 on: March 26, 2015, 12:14:18 PM »
Stew,
Nice idea.... :thumbup:
Is  there something supporting the stock at the tail end?
Looks like there's something in the chuck?
Logged
eccentric millionaire financed by 'er indoors
Location:  Backworth Newcastle

Skype: chippiejnr

Offline sbwhart

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 3530
  • Country: gb
  • Smile, Be Happy, Have Fun and Rock Until you Drop
Re: Parting Off Tool Made From 1/64" Slitting Saw
« Reply #2 on: March 26, 2015, 12:21:10 PM »
Hi John

Its just a bit of wire to catch the spacers, there that small they just lose them self s in the tray.

Stew
Logged
A little bit of clearance never got in the road
 :wave:

Location:- Crewe Cheshire
Pages: [1]   Go Up
« previous next »